#Backup exec discovering devices 32 bit
#Backup exec discovering devices windows

NAS devices using the Windows Server operating system.9 B. This information also get collected when collecting logs using Veritas QuickAssist.1 WHITE PAPER Data Protection Solutions for Network Attached Storage VERITAS Backup Exec 9.0 for Windows Servers VERSION INCLUDES TABLE OF CONTENTS STYLES 1Дў TABLE OF CONTENTS Background.3 Why Use a NAS Device?.4 What about Storage Area Networks (SAN)?.5 NAS, VERITAS and Microsoft Windows Server Appliance Kit.6 Value of Using VERITAS Backup Exec With NAS Devices.7 Supported Environments.8 Backup Strategies.9 NAS Device Operating Systems.9 Backup Exec Support of NAS.9 A. The log file is under the Backup ExecВ directory, on the driveВ where backup exec is installed. To change the direct access port, delete Remote Agent configured for deduplication from the device tab then configure Remote Agent Deduplication with the new port number.ДЇor more information on adamm log, refer to related articles. Note: In Backup Exec 2010, The direct access port is not changed once Remote Agent for Deduplication is configured. If the NDMP control port of a remote server is changed, the direct access port must also be changed. The NDMP control port number is 10000 by default. The Direct access port should be the same with the NDMP control port of a remote server. Make sure that NDMP port of remote server corresponds with direct access port. If IPv6В is enabled only on anyone of the serversВ it would cause communication issues with Client-side Deduplication.

Make sure thatВ IPv6 is enabled on both BE or remote server. Add the host file entries on the remoteВ server where 'Remote Media agent' option isВ configured and on the media server as wellВ and recycleВ the remote agent service & BackupВ exec services. Otherwise, client-side deduplication does not occur If you use the IP address, you must also use the IP address for the backup selection. or IPv6 is enabled only on one of the servers, either BE server or Remote server but not both.Client-side deduplication is not supported for off-host backups. or the host file entries are not added on the remoteВ server where ' Remote Media agent' option isВ configured.or the Remote Agent with Deduplication name does not match the Remote Agent name.or the Backup Exec PureDisk FileSystem Service is stuck.The Remote Agent for Windows on the remote computer has not been configured as a Remote Agent with Deduplication.The ' Use client-side deduplication'В option has been selected in the backup job Properties in the Device and Media tab.ДЄnd one of the following conditions occurs:.The Destination Device for a job is a Deduplication Storage Folder or an Open Storage Technology (OST) Device.

#Backup exec discovering devices 32 bit

Client-side Deduplication is not supported for 32 bit Remote Agents in Backup Exec 21.

The above exception is noticed in a backup job log if the following is true: This document covers the troubleshooting steps necessary to determine the root cause. There are several potential causes for this warning. Verify that the Remote Agent for Deduplication is configured properly, and then run the job again.Д¬lient-side deduplication is enabled for this job, but it could not be used.ДЄdamm.log: 'NDMP Server inaccessible, unsupported, or has no devices.' Cause V-79-40960-39700 The job failed because the Remote Agent for Deduplication is not set up properly to enable client-side deduplication in a private cloud. A backup job using Backup Exec Deduplication Option completes with the following exception: Error Message